
E-DOC-CTC-20061027-0004 v1.0
Systemlog Commands
687
systemlog show
Show messages in the internal Syslog message buffer.
SYNTAX:
where:
systemlog show [fac = <supported facility name>]
[sev = <supported severity name>]
[hist = <{disabled | enabled}>]
fac Specify the facility name of the syslog messages to be shown.
Use one of the supported facility names (see “ Supported System
Logging Facilities” on page 791).
Note If not specified, the messages of all the facilities will be
shown.
OPTIONAL
sev Specify the lowest priority severity of the syslog messages to be
shown.
All the syslog messages with severity as specified or higher will be
shown.
Use one of the supported severity names (see “ Supported System
Logging Severities” on page 792).
Note If not specified, the messages of all the severities will be
shown.
OPTIONAL
hist Show messages over several Thomson ST reboots (enabled) or show
only messages since latest startup (disabled).
Note If not specified, only the recent messages will be shown.
OPTIONAL
Comentarios a estos manuales