
E-DOC-CTC-20061027-0004 v1.0
IP Commands
433
EXAMPLE:
addrcheck Set the level of IP address checks.
Choose between:
> off: No address checking is performed. For advanced
users only; in normal circumstances there should always
be some kind of address checking.
> own: Minimum level of checking.
Only the address configuration on the Thomson ST is
checked.
> static: Checking of the address configuration of the
Thomson ST and also of traffic: addresses of incoming
packets; this checking is related to constants (for
example an address may not be entirely composed of
one‘s or zero‘s).
> dynamic: Besides the address configuration of the
Thomson ST itself, and besides the checking of traffic on
a constants level, additional checking is performed on
the IP addresses that are determined by the
configuration, more specifically by the network.
The default is dynamic.
OPTIONAL
mssclamping Disable or enable mss clamping for low MTU interfaces.
Enabling mss clamping assures that the size of a TCP packet
never exceeds the available Maximum Transmission Unit
(MTU) of the outgoing interface.
The default is on.
Note It is recommended not to disable this parameter.
OPTIONAL
natloopback Disable/Enable NAT loopback.
The default is enabled.
OPTIONAL
loadbalancing Select loadbalancing mechanism OPTIONAL
bitrate-window(sec) A number between 10 and 3600.
Set the window to calculate the bitrate (multiple of 10).
The default is 30.
OPTIONAL
acceleration Disable/Enable IP acceleration OPTIONAL
=>ip config
Forwarding enabled
Sendredirects enabled
IP options enabled
NetBroadcasts disabled
Default TTL 64
Fraglimit 64 fragments
Fragcount currently 0 fragments
Defragment mode : enabled
Address checks : dynamic
Mss Clamping : enabled
NAT Loopback : enabled
Bitrate window (sec), multiple of 10 : 30
=>
Comentarios a estos manuales